Radio Reset (Reset) - Silvercrest SAR 28 A1 Operating Instructions Manual

Display
GB
IE

Radio reset (RESET)

Settings using the SEL button (EQ/LD/TA/AF)
14
♦ Keep pressing the BD/DISP
displayed in turn:
Radio station, time (automatically set with RDS reception), frequency and PTY set-
tings (these RDS functions are sent by broadcasting services in various volumes;
also refer to Section "Radio functions").
NOTE
If you are not receiving any RDS or PTY information, PTY NONE is shown on
►
the display.
To reset the device to its default factory settings, keep the RESET
pressed for about 6 seconds with a sharp object, such as a pen.
NOTE
► To access the RESET button, the face plate must be completely removed,
see also Section "Removing the face plate".
Reset the device:
▯ when using for the fi rst time,
▯ after connecting the cables,
▯ when not all function buttons are working,
▯ when an error message is shown on the display.
♦ Press the SEL button on the device. The current volume level is shown.
18
Each further press of the SEL button accesses the next setting.
The following settings are possible:
VOL - Volume (from 0 to 47)
BAS - Bass (from -7 to +7)
TRE - Treble (from -7 to +7)
BAL - Balance (sound distribution between the right and left speakers),
from 0L to 9L and 0R to 9R
FAD - Fader (sound distribution between the front and rear speakers),
from 0F to 9F and 0R to 9R
♦ Turn the multi-controller
displayed.
Handling and use
button to have the following information
7
to change the settings of the menu item
17
22 button
SAR 28 A1