Whirlpool ET20DK Use & Care Manual page 4

Install properly...
1.
Allow'~ Inch (125 cm] space on each side and
at the top of the refrrgerator for ease of
rnstallatron
2. If the refrigerator
IS
to be against a wall
yOJ
might want to leave extra space so the door
can be opened wrder
3. The refrigerator back can be flush against the
wall
Level refrigerator-freezer...
FRONT
ROLLER
VELLING SCREW
IGHT TO RAISE;
LEFl TO LOWER
1. Remove base grille [see page 7).
2. To raise front, turn screw in direction shown
3. To lower front, turn screw in the direction shown
4. Check with level.
5. Replace base grille (see page 7).
Remove sales labels...
Remove the Consumer Buy Guide label, tape
and any inside labels before using the re-
frigerator. To remove any remaining glue:
1. Rub briskly with thumb to make a ball then
remove.
OR
2. Soak area with liquid hand dishwashing
detergent before removing glue as described
in step 1.
DO NOT USE rubbing alcohol or flammable or
toxic solvents, such as acetone, gasoline, car-
bon tetrachloride, etc. These can damage the
material.
NOTE: DO NOT REMOVE ANY PERMANENT IN-
STRUCTIONS LABELS INSIDE YOUR REFRIGER-
ATOR.
Do not remove the Tech sheet fastened under
the refrigerator at the front.
Clean it...
Clean your refriger-
cttor before using It
See cleaning instruc-
tions on page 9 m
u
Plug it in...
3-PRONG GROUNDING
TYPE WALL RECEPTACLE\
REFRIGERATOR
3-PRONG
POWER CORD
GROUNDING PLUG
RECOMMENDED GROUNDING METHOD
A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused
and properly grounded electrrcal supply is
required It IS recommended that a separate crr-
curt serving only this appliance be provided
Do not use an extension cord. Use a recepta-
cle which cannot be turned off with a switch or
pull chain. See individual electrical requirements
2nd groundrng Instruction sheet in your literature
oackage