Table of Contents
Advertisement
7.2 Additional introduction to the remote controller for HBU-14 series
Remote controller
24
25
26
27
28
AUTO
29
C
30
ON
OFF
31
32
1
TEMP
2
ON
OFF
SWING
FAN
3
4
MODE
FILTER
CLOCK
SET
5
6
SLEEP
TIMER
LOCK
RESET
7
8
Note:
If the filter does not thoroughly back to the original position,only need to
operate several times repeatedly.
13. FILTER Button
Used to set up/down function of the filter.
23
After air conditioner operated for a period, dusts were
22
gradually accumulated on the filter ,and the filter up/down
21
function can be used to clean the filter.
20
19
1.Whether unit start or stop, continuously press FILTER
18
button 3 seconds,and enter into the filter up/down waiting
17
status (when unit stops,the yellow TIMER indicator flashes,
16
filter and clock displayed on the remote controller and no
others.Only the FILTER button and the temperature button
15
and time button
" " " "
2.Press temperature
14
up/down waiting status, the up/down mechanism makes
the filter to move downward and do not stop until reach
13
the maximum limit.
3.Press temperature
12
up/down waiting status , the up/down mechanism makes
11
10
the filter to move upward till near to the surface board and
then automatically adjust to reset (when adjusting to reset,
9
it will not be controlled by the remote controller till the adju-
stment is finished, and the remote controller can control
again.
4.During moving downward ,press temperature
or time
" "
5.During moving downward ,press temperature
or time
" "
6.Continuously press FILTER button 3 seconds again to
cancel the filter up/down waiting mode (unit stops, the
yellow timer indicator stops flashing, the filter backs to
the original position , the remote controller backs to off
status and only clock is displayed).
- 43 -
REMOTE CONTROLLER FUNCTIONS
" " " "
button or time
" "
button or time
" "
button, moving stops.
button, moving stops.
are active).
" "
button in filter
button in filter
" "
button
" "
button
" "
Hide quick links:
Advertisement
Table of Contents
