Bar Code Processing Examples - Honeywell MX7 Tecton Reference Manual

Bar Code Processing Examples

The following table shows examples of stripping and prefix/suffix configurations. The examples assume that the scanner is
configured to transmit an AIM identifier.
Enable
Min length
Max length
Strip Code ID
Strip Leading
Strip Bar Code Data
Strip Trailing
Prefix
Suffix
Provided that the wedge is configured with the above table, below are examples of scanned bar code data and results of these
manipulations.
Bar code Symbology
EAN-128
EAN-128
EAN-128
EAN-13
EAN-13
EAN-13
I2/5
I2/5
I2/5
I2/5
Code-93
Code-93
Code-39
Code-39 full ASCII
Code-39
Note: Rejected bar codes generate a bad scan beep. In some cases, the receipt of data from the scanner triggers a good
scan beep (from the external scanner), and then the rejection of scanned bar code data by the processing causes a
bad scan beep on the same data.
4-120
All EAN-128(]C1)
Enabled Enabled
1 4
all all
Enabled Enabled
3 0
*123
0 0
aaa bbb
www xxx
Raw Scanner Data
]C11234567890123
]C111234567890123
]C1123
]E01234567890987
]E01231234567890987
]E01234
]I04444567890987654321
]I04444567890123
]I0444
]I022245622
]G0123456
]G0444444
]A01234567890
]A41231234567890
]A4
Symbology
EAN-13(]E0) Intrlv 2 of 5(]IO)
Enabled Enabled
1 1
all 10
Disabled Enabled
3 3
1* 456
3 3
ccc ddd
yyy zzz
Resulting Data
bbb1234567890xxx
bbb11234567890xxx
< rejected > (too short)
ccc]E04567890yyy
ccc]E0234567890yyy
ccc]E0yyy
< rejected > (too long)
ddd7890zzz
dddzzz
ddd45zzz
< rejected > (disabled)
< rejected > (disabled)
aaa4567890www
aaa1234567890www
< rejected > (too short)
Code93
Disabled