Pride Elite Trsveller Owner's Manual page 22

I I I . Y O U R T R A V E L S C O O T E R
SHROUD PANELS
You can change the colour of your Travel Scooter by
removing the coloured plastic shroud panel pieces and
replacing them with one of the other supplied sets. The
panels are held in place by a hook and loop reusable
fastener.
To remove the shroud panel pieces:
1. Use your finger to locate the push hole behind each
shroud piece.
2. Push through the hole to separate the piece from the
Travel Scooter. See figures 13 and 14.
To remove the tiller console visor:
1. Gently pull the top of the visor away from the tiller
console, then slowly lift it up and away from the tiller
console. See figure 15.
To reinstall the shroud pieces, place each piece in its
appropriate location and push with slight pressure to secure
the reusable fastener.
NOTE: When installing the front and rear fender panels,
make sure the tab at the bottom of each panel is inserted
into the tab opening before securing the panel. See
figure 13.
22
www.pridemobility.com
TAB
Figure 13. Front Fender Panel
PUSH HOLE
Figure 14. Rear Fender Panel
Figure 15. Tiller Console Visor
Elite Traveller