Download  Print this page

Pioneer VSX-RS320-k Operating Instructions Manual Page 41

Audio/video multi-channel receiver.
Hide thumbs

Advertisement

Additional information
Problem
Considerable noise in radio
broadcasts.
Broadcast stations cannot be
selected automatically.
No sound from surround or
center speakers.
No sound from subwoofer.
The PHASE CONTROL feature
doesn't seem to have an
audible effect.
Noise during playback of a
cassette deck.
No sound is output or a noise
is output when software with
DTS is played back.
During a playback search,
noise is output from a DTS
compatible CD player.
Remedy
• Connect the antenna (page 22) and adjust the position for best
reception.
• Route any loose cables away from the antenna terminals and wires.
• Fully extend the FM wire antenna, position for best reception, and
secure to a wall (or connect an outdoor FM antenna).
• Connect an additional internal or external AM antenna (page 22).
• Turn off equipment causing interference or move it away from the
receiver (or move antennas farther away from equipment causing
noise).
• Connect an outdoor antenna (refer to page 22).
• Connect the speakers properly (refer to page 14).
• Refer to Speaker setting on page 32 to check the speaker settings.
• Refer to Channel level on page 33 to check the speaker levels.
• Make sure the subwoofer is switched on.
• If the subwoofer has a volume knob, make sure it's turned up.
• The Dolby Digital or DTS source you are listening to may not have
an LFE channel.
• Switch the subwoofer setting in Speaker setting on page 32 to YES
or PLUS.
• Switch the LFEATT (LFE Attenuate) on page 30 to LFEATT 0 or
LFEATT 10.
• If applicable, check that the lowpass filter switch on your
subwoofer is off, or the lowpass cutoff is set to the highest frequency
setting. If there is a PHASE setting on your subwoofer, set it to 0º (or
depending on the subwoofer, the setting where you think it has the
best overall effect on the sound).
• Make sure the speaker distance setting is correct for all speakers
(see Speaker Distance on page 34).
• Move the cassette deck further from your receiver, until the noise
disappears.
• Make sure the player's settings are correct and/or the DTS signal out
is on. Refer to the instruction manual supplied with the DVD player.
• Set the input signal type to C1/O1/O2 (DIGITAL) (see Selecting the
audio input signal on page 25).
• This is not a malfunction, but be sure to turn the volume down to
prevent the output of loud noise from your speakers.
09
41
En

Advertisement

Table of Contents

   Related Manuals for Pioneer VSX-RS320-k

Comments to this Manuals

Symbols: 0
Latest comments:
  • lovemore Dec 31, 2016 12:25:
    pioneer vsx-rs320 not coming on but was switched off yesterday
    ​what could be the problem ?
  • hamedparto Jul 14, 2016 09:59:
    please internal map Pioneer VSX-RS320-​k
  • hamedparto Jul 14, 2016 09:45:
    hello
    pleas map Pioneer VSX-RS320-​k