3-1-4. Adjusting Buttons and Indicator
MUTING
Adjustment item
up
Adjustment item
down
Initialize data
(Not stored)
User control goes
to the standerd state
(Shipping Conditions)
VOL +
RM-Y914
FUNCTION OF KEYS ON COMMANDER
• 1
: Changes adjustment item. (item No. moves up)
• 4
: Changes adjustment item. (item No. moves down)
• 2
: Changes adjustment category.
(category moves up)
• 5
: Changes adjustment category.
(category moves down)
• 3
: Changes data value. (up)
• 6
: Changes data value. (down)
Commander Function
Button
Mode
[MUTING] + [ENTER]
WRITE
- + [ENTER]
READ
8 + [ENTER]
RESET
3-2. To read Lamp and Panel time
The lamp and panel time of the set are displayed as follows .
<Enter the service mode>
1. Press the keys of the remote commander in rapid sequence as fol-
lows , when the set is in standby mode.
t Channel 5
DISPLAY
2. Press the "JUMP " key [3 times].
You'll get into DE-micro service menu .
3. Press "2 " key [20 times] to show the following display .
Example
PANEL
NVM OK
20 Timer
0 LMP
461
Diff
1
POWER
DISPLAY
Adjustment category
up
Data up
Data down
Adjustment category
down
ENTER
Read data from
NVM
Description
Writes data to NVM.
Reads data from NVM.
Set the shipping condition.
t Vol +
t
POWER
4. To reset Lamp Time, press "2 " key [1 more time] to show the
following display .
Example
PANEL
NVM OK
20 Timer
1 LMPRST
Diff
1
Then press "3" , "MUTE " and "ENTER " keys in sequence. The
Lamp Time will be reset.
5. To check Panel Time, press "2" key [1 more time] at the previous
display of Lamp Time.
The following display will be shown.
Example
PANEL
NVM OK
20 Timer
2 OPERAT
465
Diff
1
You can not reset the Panel Time with the Service menu .
<To get out of the Service menu>
The Service menu is cleared by turning off the set with a remote com-
mander or the power switch .
3-3. Test Reset
The user settings can be reset to the factory default condition as fol-
lows.
1. Press "TEST " and "RESET " key in sequence when the set is ON .
The LAMP,TIMER and POWER/STANDBY LED light and the
picture is muted.
After about 5 seconds the LAMP and TIMER LED go off,
and the color of POWER/STANDBY LED changes from amber
to green.
After another 10 seconds the reset is completed and the initial set-
up display appears.
– 24 –
KDS-R50XBR1/R60XBR1
RM-Y914
0
RM-Y914