"High Temperature Warning!"
The signal from a selected
i.LINK device is not being
The TV does not turn on.
This message will appear when there is a rise in temperature inside the TV. Make
sure to remove dust from the ventilation slots on the rear and both sides of the TV.
In addition, make sure that there are no obstacles in front of the ventilation slots.
If no blockage is found, you may need to set High Altitude mode to On,
otherwise the TV will turn off. With High Altitude set to On, if the message
reappears and TV turns off again, the TV may need servicing. Call your local
Sony Service Center.
If you have several i.LINK devices connected and operating at once, the TV may
not be able to display the signal from the selected device. Turn the other i.LINK
devices off, and reselect the desired i.LINK device.
If you are using a digital VCR, turn off any Auto LINC functionality of the VCR.
For details, see the digital VCR's user manual.
The TV cools down its projection lamp when the power is turned off. It takes up to
two minutes for the picture to come back after the TV is turned on again. Wait for
a while until the picture comes back.