I cannot get Twin View to
There is no Twin View window,
or it is just static.
Twin View cannot display
anything but TV channels.
Twin View displays the same
program in both windows.
Remote control does not
Cannot change channels with
the remote control.
If you are using a cable box to unscramble all channels (as shown on page 25),
you cannot use the Twin View feature. This is because the cable box can
unscramble only one channel at a time.
You can use Twin View to view a signal from a different source that is connected
to the TV's A/V jacks (such as a VCR or DVD player) in the second window by
pressing TV/VIDEO while in Twin View.
Sources connected to the VIDEO 4, VIDEO 5, VIDEO 6 and VIDEO 7 inputs, as
well as digital sources display only in the left Twin View window.
Twin View is not available when using VIDEO 8 (PC) IN or i.LINK input.
Be sure the Twin View window is set to a video input or channel that has a signal
You might be tuned to a video input with nothing connected to it. Try cycling
through the video inputs by pressing TV/VIDEO.
Try cycling through the video inputs by pressing TV/VIDEO. Check that the
Label Video Inputs option is not set to Skip. (See the Setup setting on page 96.)
Both Twin View windows might be set to the same channel. Try changing
channels in either window.
The batteries could be weak. Replace the batteries.
Check the orientation of the batteries.
Press FUNCTION repeatedly until the TV indicator lights up. You may have
inadvertently pressed FUNCTION, which changes the remote control to SAT or
Make sure this unit's power cord is connected securely to the wall outlet.
Locate the unit at least 3-4 feet away from fluorescent lights.
If the "High Temperature Warning!" message appears, turn off the TV and wait
until the TV's projection lamp cools down (approximately 5 minutes). If the
remote control still does not work, make sure to dust the ventilation slots on the
rear of the TV and the cooling fan to provide adequate ventilation around the TV.
If you are using the TV to change channels, first press FUNCTION repeatedly
until the TV indicator lights up.
If you are using another device to change channels, be sure you have not
inadvertently switched your TV from the channel 3 or 4 setting. Use the Channel
Fix option to "Fix" the channel based on the hookup you used (see page 90).
If you are using another device to change channels, be sure to press FUNCTION
for that device. For example, if you are using your cable box to change channels,
be sure to press FUNCTION repeatedly until the SAT/CABLE indicator lights up.