Miele CVA 2650 Operating Instructions Manual page 85

www.dexpress.com
,
CAUTION: Before installation or
servicing, disconnect the power
supply by either removing the fuse,
shutting off the power main or
manually "tripping" the circuit
breaker.
Installation work and repairs should
only be performed by a qualified
technician in accordance with all
applicable codes and standards.
Repairs and service by unqualified
persons could be dangerous and
the manufacturer will not be held
responsible.
Before connecting the appliance to
the power supply, make sure that
the voltage and frequency listed on
the data plate correspond with the
household electrical supply. This
data must correspond to prevent
appliance damage. Consult an
electrician if in doubt.
Only operate the cooktop after it has
been installed into the countertop.
Installer:
Please leave these instructions with
the consumer.
Power supply
^ Be sure your electrical supply
matches the data plate.
www.dexpress.com
Cond Inst
Electrical connection
Connection
The cooktop is equipped with a flexible
metal conduit encasing 3 wires ready
for connection to a grounded power
supply.
208/240 V, 60 Hz, 40 A fuse rating.
Black wire: connect to L1 (hot)
Red wire:
Green wire: connect to GND (ground)
A dedicated line and junction box
should be used to connect the cooktop
to a 40 A circuit.
For further information, see the wiring
diagram provided with the appliance.
, WARNING:
THIS APPLIANCE MUST BE
GROUNDED!
Cond Inst
Page 85 of 105
connect to L2 (hot)
Page 85 of 105
KM5
KM5
47