Table of Contents
Advertisement
Useful Information
Menu list
Problem
The display is in a
language I cannot read.
I cannot activate the eco
mode.
I cannot display the
wallpaper.
I cannot register a handset
to a base unit.
Battery recharge
Problem
The handset beeps and/or
flashes.
I fully charged the
batteries, but
–
still flashes or
– the operating time
seems to be shorter.
Making/answering calls, intercom
Problem
is displayed.
42
PRS110FX(en)_0725_ver020.pdf
Cause/solution
R Change the display language (page 12).
R You cannot set eco mode when you set the DECT repeater
mode "On". If required, set the DECT repeater mode to "Off"
(page 32).
R Wallpaper is displayed in the standby mode only when you
select "Digital(Small)" or "Off" for the clock setting.
Change the clock setting (page 23).
R The maximum number of base units (4) is already registered to
the handset. Cancel unused base unit registrations from the
handset (page 32).
R The maximum number of handsets (6) is already registered to
the base unit. Cancel unused handset registrations from the
base unit (page 32).
R You entered the wrong PIN. If you forget your PIN, contact an
authorised service centre.
Cause/solution
R Battery charge is low. Fully charge the batteries (page 9).
R Clean the battery ends (
a dry cloth and charge again.
R It is time to replace the batteries (page 9).
Cause/solution
R The handset is too far from the base unit. Move closer.
R The base unit's AC adaptor is not properly connected.
Reconnect AC adaptor to the base unit.
R The handset is not registered to the base unit. Register it
(page 31).
R Activating one touch eco mode reduces the range of the base
unit in standby mode. If required, turn eco mode off (page 12).
42
,
) and the charge contacts with
2013/07/25
9:56:14
Advertisement
Table of Contents
