Troubleshooting - Samsung DCB-P850Z(S) Instructions For Use Manual

Problem
No display on the front panel;
No power supply
No pictures on the screen.
No sound.
Remote Control does not
operate directly.
Poor picture.
On-Screen Error Message
"No signal."
On-Screen Error Messages:
"No card inserted."
On-Screen Error Message
"No access"
DISPOSAL
The device, packaging material (e.g. Styrofoam) and the batteries must never be disposed of
with household refuse.
Please obtain appropriate information about the regulations in your community, and dispose of
all refuse in accordance with regulations at the separate locations provided.
DCB-P850Z,P850ZS(GB).indd 59

TROUBLESHOOTING

Possible cause
Power cord not plugged in
correctly.
Receiver in Standby mode;
SCART not connected tightly
to video output of television;
Incorrect channel or video output
selected on television.
Audio cord connected incorrectly;
Volume level = 0;
Muting active.
Incorrect operation;
Batteries dead or inserted
incorrectly.
Signal strength too low.
Antenna cable not connected or
not tight;
Incorrect connection of the
antenna.
Smartcard:
- not plugged in correctly;
- not plugged in.
No access to this channel.
GB-5
Solution of the problem
Power cord plug in correctly.
Set Receiver to "On"; Check
connection and correct; Check
channel and video output and correct.
(TV instruction manual)
Check connection and correct;
Increase volume on television set;
Press the (MUTE) button.
Point remote control toward the
Receiver.
Replace batteries or insert correctly.
Check the signal strength in the Info
Menu, correct alignment of your
antenna.
Check connection and correct;
Check the signal strength in the Info
Menu.
(depending on models)
Check the Smartcard.
"Insert the Smartcard."
Check that you subscribe to this
channel. If the STB has been
switched off for a longer period of
time, turn on the STB, select any
channel, and wait for authorization for
up to 60 minutes.
2008-09-05 오후 3:13:30