Setting Up The Projector - Dell 2200MP User Manual

4. Remote Control

SETTING UP THE PROJECTOR

1. Plug power cord into Projector and an outlet
2. Put one ends of the VGA cable into the Monitor-in
3. Put the other blue end of the VGA cable into the correct port of your laptop.
4. NOTE!!
need a converter that will connect from your digital port to the VGA cable. (Included in projector
case)
5. Put the small end of the USB cable in its port on the projector
6. Plug the USB end of the USB cable into your computer
7. NOTE!!
USB and VGA cables should suffice, unless you are adding audio using the projector. Refer to
the Owner's Manual for further instructions.
8. Remove the lens cap
9. Once your computer is on and ready, push the Function-F8 key
10. Turn the projector on by pressing the Power button
11. NOTE!!
this is fine, it is just recognizing the power source
Y/AC/Staff/Documentation/ProjectorGuideShort 11/05 cc
This Manual: http://www.manuallib.com/file/2589655
If you are using a Mac and have a digital port rather than analog, you
The projector can hook up to many sources using different cables. For a laptop, the
If the projector is plugged in and the power is off, the power button may blink green-
1. Light
2. Power button
3. Previous page button (page up)
4. Four Direction buttons
5. Source button
6. Resync button
7. Keystone Correction button
8. Volume button
9. Hide button
10. 4:3/16:19 (aspect ratio) button
11. Menu button
12. Next page button (page down)
13. Video Mode button
1
If your image is blurry, try twisting the
focus ring
**
– USB Needed
2