Using The Ptz Camera - Samsung SDS-P3042 User Manual

main menu

Using the PTZ camera

You can use one camera to perform all functions of PAN, TILT and ZOOM for monitoring multiple places and
set the preset to your preference in a desired mode.
1. Launch the <PTZ Control> menu.
As the < > icon on the bottom right corner turns
yellow, you access the "PTZ Control" mode to display the
"PTZ Control" menu.
Be sure to configure PTZ working environments before
`
M
operation, since the PTZ Working(Active) mark can be
appeared to be activated even when PTZ is not operative.
2. Use the PTZ wheel in the launcher menu to adjust the
monitoring area, or use the direction buttons (▲▼_ +) on
the remote control to move the camera to a desired place.
• PTZ Wheel : Clicking a nearer point to the center will move in that direction slowly; clicking a farther point
from the center will move fast.
Keep clicking left to rotate the lens counter clockwise; keep clicking right to rotate the lens clockwise.
`
• Zoom ( ) : You can use the Zoom function of the PTZ camera.
• IRIS ( ) : Adjusts the intensity of radiation incoming to the iris.
• Focus ( ) : Enables you to adjust the focus manually.
• Swing : Moves between the preset start point and end point.
• Group : Moves in the path specified by combining the preset, pattern and auto pan.
• Trace : Moves camera's framing in the predefined path.
• Preset : Sets the preset position for camera framing and moves to designated preset position when
selecting a desired preset.
• Tour : Moves in the path specified by combining multiple groups.
For the coaxial communications, the operation may differ depending on the protocol.
`
For the <Coaxial> type, only SDR-5102 are supported.
`
Before entering the PTZ device control mode, set the values of the PTZ device in the <Setting the PTZ> menu.
`
M
(Page 46)
For camera specifications that supports PTZ comtrol depending on communication method, refer to our web site.
`
74_ main menu
2013-01-01 01:10:25
PTZ Control CAM01
Swing Select
Group Select
Trace Select
Preset Select
Tour
Exit
Camera Setup
Select Preset
Save Rename
Delete Delete All