Initial Settings; Turn On The Power - JVC LVT1627-001A Instructions Manual

Initial settings

When you turn on the unit for the first time, the initial setup screen appears. Follow the procedure
below and make necessary settings.

Turn on the power.

Adjust the following settings.
Select an item
Proceed to the next setting
Back to the previous setting
1
Language
Select the language you want for the
display and the voice guidance.
2
Store Display Mode
Select Off.
• If you select On, the System starts in
the navigation demonstration mode
for shops. (☞ [47])
3
Installation Angle
Select which angle your unit is installed
at. This setting is necessary for the
precise functioning of the Navigation
System.
• See "Measuring the installation
angle" on the Installation/Connection
Manual.
4
Time Zone
Select your residential area for clock
adjustment.
8
Language
English US
Español
Français
5
6
You can also change these settings (except
Store Display Mode) through Setup
Menu and AV Menu when necessary.
• Language ☞ [46]
• Installation Angle ☞ [46]
• Time Zone ☞ [91]
• DST ☞ [91]
• Reverse Polarization ☞ [94]
DST
Select Auto if your residential area is
subject to DST (Daylight Saving Time).
Reverse Polarization
Engage the parking brake, step on the
brake pedal, then switch the gear lever.
If Forward and Reverse alternates
on the display, connection is correct.
Select one of the alternatives (GND or
Battery) that shows the gear position
correctly.
Finish the procedure.