Specifications; Standard Accessories; Prior To Operation - Hitachi FM 8 Handling Instructions Manual

17. Avoid unintentional starting. Do not carry a
plugged-in tool with a finger on the switch. Ensure
switch is off when plugging in.
18. Use outdoor extension leads. When tool is used
outdoors, use only extension cords intended for
outdoor use.
19. Stay alert. Watch what you are doing. Use common
sense. Do not operate tool when you are tired.
20. Check damaged parts. Before further use of the tool,
a guard or other part that is damaged should be
carefully checked to determine that it will operate
properly and perform its intended function. Check
for alignment of moving parts, free running of moving
parts, breakage of parts, mounting and any other
conditions that may affect its operation. A guard or
other part that is damaged should be properly
repaired or replaced by an authorized service center
unless otherwise indicated in this handling instruc-
tions. Have defective switches replaced by an au-
thorized service center. Do not use the tool if the
switch does not turn it on and off.

SPECIFICATIONS

Voltage (by areas)*
Power input
No-load speed
Collet chuck capacity
Main body stroke
Weight
*Be sure to check the nameplate on product as it is subject to change by areas.

STANDARD ACCESSORIES

(1) Parallel Guide Ass'y ................................................... 1
(2) Template Guide .......................................................... 1
(3) Wrench ........................................................................ 2
(4) Screws (for mounting the temeplate guide) ............ 2
One scale, one knob screw, two wing bolts, and two lock
springs are packaged together with the standard accesso-
ries (2), (3), and (4) mentioned above.
Standard accessories are subject to change without
notice.
OPTIONAL ACCESSORIES-sold separately
1. Feed Screw Assembly
2. Trimmer Guide Assembly
21. Warning
The use of any accessory or attachment, other
than those recommended in this instruction
manual, may present a risk of personal injury.
22. Have your tool repaired by a qualified person.
This electric tool is in accordance with the relevant
safety requirements. Repairs should only be car-
ried out by qualified persons using original spare
parts. Otherwise this may result in considerable
danger to the user.
PRECAUTIONS ON USING ROUTER
1. Single-hand operation is unstable and dangerous. Ensure
that both handles are gripped firmly during operation.
2. The bit is very hot immediately after operation.
Avoid bare hand contact with the bit for any reason.
(110V, 115V, 120V, 127V, 220V, 230V, 240V)
550W*
27000/min
8mm or 6.35mm(1/4") or 6mm
52mm
2.3kg (without cord and standard accessories)
3. Chuck Sleeve
4. Collet
8mm, 6.35mm, 6mm
Optional accessories are subject to change without no-
tice.
APPRICATIONS
Woodworking jobs centered on grooving and cham-
fering.

PRIOR TO OPERATION

1. Power source
Ensure that the power source to be utilized con-
forms to the power requirements specified on the
product nameplate.
English
8 × 6 Chuck Sleeve
8 × 6.35 Chuck Sleeve
19