Replacing The Battery - JVC KV-MR9000 Instructions Manual

Before using the remote controller:
When you use the remote controller for the
first time, pull out the insulation sheet as
illustrated to the right.
• Aim the remote controller directly at the
remote sensor on the color monitor. Make
sure there is no obstacle in between.
• Do not expose the remote sensor to strong
light (direct sunlight or artificial lighting).

Replacing the battery

When the controllable range or effectiveness
of the remote controller decreases, replace
the battery.
1. Remove the battery holder.
While pushing in the lock using a ball-point
pen or a similar tool (1), pull out the
battery holder in the direction indicated by
the arrow (2).
(back side)
2. Replace the battery.
Slide a new battery into the holder with
the + side facing upwards so that the
battery is fixed in the holder.
3. Return the battery holder.
Insert the battery holder again pushing it
until you hear a clicking sound.
(back side)
2
1
Lithium coin battery
(product number:
CR2025)
(back side)
Insulation sheet
(The battery has been installed when shipped
from the factory.)
WARNING:
• Store the battery in a place which children
cannot reach.
If a child accidentally swallows the battery,
immediately consult a doctor.
• Do not recharge, short, disassemble or heat
the battery or dispose of in a fire.
Doing any of these things may cause the
battery to give off heat, crack or start a fire.
• Do not leave the battery with other metallic
materials.
Doing this may cause the battery to give off
heat, crack or start a fire.
• When throwing away or saving the battery,
wrap in tape and insulate; otherwise, it may
cause the battery to give off heat, crack or
start a fire.
• Do not poke the battery with tweezers or
similar tools.
Doing this may cause the battery to give off
heat, crack or start a fire.
CAUTION:
DO not leave the remote controller in a place
(such as dashboard) exposed to direct sunlight
for a long time. Otherwise, it may be damaged.
Pull out
7