Replacing The Filters - Black & Decker BDH1800PL Instruction Manual

• If necessary, wash the two filters (12
and 13) in warm, soapy water.
• Make sure that the filters are dry
before refitting them to the appliance.
• Refit the pleated filter into the plastic
pre-filter.
• Refit the pre-filter into the dust container (10)
until it locks into place.
• Close the transparent door and
make sure it clicks into place. Refit to
appliance.
CLEANING THE DUST
CONTAINER (FIG. I, j)
WARNING:
without the filters. Optimum dust collection will only be achieved with clean filters.
CAUTION:
appliance on when dust container is removed.
• Push and hold the release bowl button
(5) on the dust collector.
• Rotate the handle toward the bottom of
the appliance.
• Pull the dust container to the side, and
away from the base of the appliance.
NOTE:
You can then remove the filters
as described above, or remove only the
pleated filter (13) by pulling it firmly from the
now exposed side.
• Once filters are removed, wipe the dust
container with a damp cloth, or rinse with
warm soapy water and allow to dry as
shown in figure j.
• To replace the dust container, with the
filters installed slide the container back
onto the base and rotate the handle toward
the front of the appliance until an audible
click is heard. Ensure that the container is
fully fastened back onto the base.

REPLACING THE FILTERS

The filters should be replaced every
6 to 9 months and whenever worn or damaged. Replacement filters are available from
your Black+Decker dealer (cat. no. PVF110):
• Remove the old filters as described above.
• Fit the new filters as described above.
Projectile/Respiratory Hazard: Never use the appliance
Do not turn
6
H
I
J
12 13
10