To Charge The Appliance; Switching On And Off; Optimizing The Suction Force - Black & Decker BDH1800PL Instruction Manual

TO CHARGE THE APPLIANCE:

• Make sure the appliance is switched off.
The battery will not be charged with the on/
off On/Off switch (1) in the On position.
• Plug the charging base (11) into a
standard 120 Volt 60 Hz electrical outlet.
• Lower the appliance onto the charging
base. The blue LED (3) in the base of the
appliance will illuminate to indicate that it
is charging.
• When charging is complete, the LED will
turn off.
• The charger may become warm during
charging. This is normal and does not
indicate a problem.
While it is safe to leave the appliance
connected to the charger indefinitely,
to reduce power consumption, we
recommend unplugging the charger after
24 hours.

SWITCHING ON AND OFF

(FIG. E)
• To switch the appliance on, slide the on/
off switch (1) forward to position I.
• To switch the appliance off, slide the on/
off switch (1) back to position 0.
OPTIMIzING THE SUCTION
FORCE
Rotating the bowl agitates the filter to remove
dirt; however, in order to keep the suction force
optimized, the dust container and filters must
be cleaned regularly during use.
CLEANING THE FILTERS (FIG.
F - H)
WARNING:
without the filters. Optimum dust collection will only be achieved with clean filters.
CAUTION:
appliance on when dust container is removed.
Both the plastic pre-filter (12) and the
pleated filter (13) are re-usable and should
be cleaned regularly.
• Pull the door latch (9) and open the
transparent door (8).
• Remove the pre-filter (12) from the
appliance by twisting the filter to the
right and pulling it from the appliance.
• Remove the pleated filter from the pre-
filter by pulling firmly.
• Tap the filters vigorously to remove
loose dust.
Projectile/Respiratory Hazard: Never use the appliance
Do not turn
5
D
E
F
G
12
12
13