Canon Image Runner 2000 Series Manual page 12

1
1-4 Flow of Copy Operations
Staple copy: place the original face up
Copies are stapled here.
ABC
Vertical Placement
IMPORTANT
The copies are stapled at the part equivalent to the upper left side of the original.
NOTE
• If the top edge of the original is not aligned with the back edge of the platen glass
(by the arrow in the top left corner), prints may not be made correctly, depending on
the mode you have set.
• STMT and LTR originals can be placed either vertically or horizontally. However,
the scanning speed for horizontally placed originals is somewhat slower than for
vertically placed originals. You can place originals horizontally when printing with a
Preset Zoom, such as when processing LTR
• Horizontally placed LTR, LGL and 11''x17'' originals are referred to as LTR ,
LGL and 11''x17'' .
• LGL and 11''x17'' originals must be placed horizontally.
• If <AUTO SORT> is set to <ON>, the Collate or the Offset Collate mode is
automatically set if you place your originals in the feeder. (See "Auto Collate," on p.
3-8.)
G
If the message <ENTER DEPT. ID> is displayed:
I Enter the Department ID and password. (See the Reference Guide.)
Feeder
Copies are stapled here.
Original
(face up)
Horizontal Placement
to 11''x17'' .
ABC
Original
(face up)