Out Of Range; No Remote Output; Feature Not Available - Python 872 Owner's Manual

Out of Range
Each time a command is performed the Responder LE will expect a
command confirmation from the system. If a command confirmation
is not received the
f
and transmit LED's flash and a long fault tone
plays as an alert.
No Remote Output
Occasionally when a command is performed the remote may not
generate a command confirmation output or Out of Range output.
This indicates that the system received the command but it was an
incomplete command {e.g. Aux button pressed too short to activate
the trunk release) or it was an illegal message (e.g. the command
was corrupted due to local RF interference). These are temporary nor-
mal functions of the system and remote, perform the command again
within
l
0 seconds to return to normal operation.
Feature not Available
The Feature Not Available output (
f
LED on and long fault tone) is a
generic one which varies in cause and solution depending upon the
command used:
36
Runtime Reset Remote Start is Off
Sensor Bypass System is not armed
Defroster Remote Start is Off.
Not configured for
this.
Only available when Remote Start is On
Only available when system is armed
Only available when Remote Start is On.
Only available when configured for
Defroster control.
© 2009 Directed Electronics. All rights reserved.