Mitsubishi Electric LMAP04-E Installation Manual page 20

Error content
5
Independent/interl (1)The LM ADAPTER is not completely
ocked LOSSNAY
can not be
(2)Setting on M-NET side is not properly
operated from the
LON side.
(3)If system controller is used together
(4)The independent/interlocked
(5)L
(6)The termination of L
(7) Binding of L
6
Air conditioner can (1)The LM-ADAPTER is not completely
not be operated
from the LON side.
(2)Setting on M-NET side is not properly
(3)If system controller is used together
(4)L
(5)The termination of L
(6) Binding of L
7 (1) Perform the LM ADAPTER'S prohibit
Prohibit local remote
controller operation
cannot be set from
the LON side.
8 (1) Perform the LM ADAPTER'S forced
Forced thermo OFF
cannot be set from
the LON side.
Cause
initialized.
completed.
LM ADAPTER is not registered to
system controller.
LOSSNAY of LM ADAPTER is not
set.
®
W network transmission
ON ORKS
wire is not properly connected.
W
ON ORKS
network is not properly set.
®
W network is
ON ORKS
not properly ended.
initialized.
completed.
LM ADAPTER is not registered to
system controller.
®
W network transmission
ON ORKS
wire is not properly connected.
W
ON ORKS
network is not properly set.
®
W network is
ON ORKS
not properly ended.
local remote controller operation
setting.
thermo OFF setting.
Checking method and remedy
Refer to 2-(1).
Refer to 2-(2).
Refer to 2-(3).
Refer to 3-(4).
Refer to 4-(4).
® Refer to 4-(5).
Refer to 4-(6).
Refer to 2-(1).
Refer to 2-(2).
Refer to 2-(3).
Refer to 4-(4).
®
Refer to 4-(5).
Refer to 4-(6).
Turn on SW1-1 of LM ADAPTER, and reset the power
supply.
Turn on SW1-8 of LM ADAPTER, and reset the power
supply.
18