Table of Contents
Advertisement
; Packet Radio "The Basics"
Section 1
The SEVENTEEN X1J4+ MODE COMMANDS AND DEFINITIONS
With the new X1-J version of theNET firmware, there also comes a set of 17 added command features. The
application of these 17 features can increase the effectiveness of your network when they are properly applied.
SEDAN
MIN
MAX
0
0
1
Host Control to enable HARDWARE HANDSHAKE; MODE FLAG in HOST MODE
Enables the use of the Esc C and Esc D commands when using the RS-232 port.
0
0
3600
CW ID repeat period in seconds.
0
Disables CW ID
6
4
10
CW ID speed (10 milliseconds per DOT)
3
0
3
Nodes broadcast enable flags: 0=None, 1=HDLC only, 2=RS-232 only, 3=Both ports.
3 = both ports if backbone access; 2=matrix; 1 if LAN or user port.
0
0
3
Crosslink select: 0=None, 1=HDLC, 2=KISS,+selectCopy, 3=KISS+ALLcopy
MATRIX mode for node stack use.
35
0
255
TX keyup delay (TXDELAY) in ten millisecond increments. 35 = 350 milliseconds; for
most transceivers, add 5 mSec for radios with relays nodes using external power amplifier.
0
0
1
Full Duplex enable.
500
0
65535 RS-232, PORT 1, node broadcast period in seconds. 600 Updates nodes every 10 minutes.
0
0
3
Node broadcast algorithm flag; 0=off, 2=RS-232 port; 1 or 3 not used.
600
600 3600
Beacon interval in seconds.
600 Although beacons are enabled in PARAMS to ID only during or after use.
1
0
2
Connect redirect to BBS
0 Controls the use/action of the "C" command, and what it will do when issued.
27
0
127
Help messages enable flag, 8 bit in TALK mode & case sensitive.
PLEASE WAIT. (1) + all sysop commands, (2) +Routes are: ALIAS:CALLSIGN
0
0
3
Hash node broadcast disable (1 bit per port)
0
0
1
If set, will enable extra alias monitoring. 0=WILL NOT recognize BBSalias, DXalias,
1
0
1
Enables automatic node reconnection after remote disconnect.
1
Enable on user accessed ports and #nodes; Disable on network step points (BBS..etc).
0
0
3
Slime trail control. Each bit controls a function; Bit 0 hides; Bit 1 causes slime to be ignored.
3
3
0
3
Digipeat control. Each Bit controls a function:
Section II
"2 N 1" Handbook
The Packet Radio
Section 2
Chapter 18 Section II
DEFINITION
0 if node is operated in simplex (normal) operation.
HOSTalias, set to 1 on user port if BBSalias is set.
Set on non gateway port(s).
; TheNET X1J4 System Node Operators Handbook __ Page 44
Buck Rogers K4ABT
by
; The X1J4 System Node Operator's (SNO) Handbook
3 will disable all #node broadcasting.
Bit 0 Node refuses L2 uplink digis.
Bit 1 Node refuses digi downlinks.
19 Enables:
Advertisement
Table of Contents
