Select Remote Control Transmission Code - Panasonic CS-XE9EKE Service Manual

• During Receiving Sound ON/OFF setting mode, press AUTO OFF/ON Button to toggle the Receiving sound.
• During H14 Abnormal Detection Selection Mode, press AUTO OFF/ON Button to toggle the Abnormal detection.
• During Ventilation Quiet mode, press AUTO OFF/ON Button to toggle the Ventilation setting.
• During Auto Filter Cleaning cancellation setting mode, press AUTO OFF/ON Button to toggle the Auto Filter Cleaning cancella-
tion setting.
• If there is no operation, or receives any remote control signal within 5 minutes, the setting mode quits.

13.4. Select Remote Control Transmission Code

• There are 4 type of remote control transmission code could be selected and stored in EEPROM of indoor unit. The indoor unit
will only operate when received signal with same transmission code from remote control. This could prevent signal interference
when there are 2 or more indoor unit installed nearby together.
• To change remote control transmission code, short or open jumpers at the remote control printed circuit board.
Remote Control Printed Circuit Board
• Under various setting mode, after select the transmission code combination of remote control, press any button of remote control
to transmit a signal to indoor unit. The transmission code will be stored in EEPROM.
• After signal is received, the various setting mode is cancelled and return to normal operation.
Transmission Code Combination
J - A
Short
Open
Short
Open
42
J - B Remote Control No.
Open A (Default)
Open B
Short C
Short D