Operation Site Selection - Epson FX-80 Operation Manual

Fx printer
Hide thumbs Also See for FX-80:
Table of Contents

Advertisement

<Repacking Steps>
r
Repacking can be carried out by following the above steps in the reverse order.
(Repacking: Shipment for repair, storage, etc.)
NOTE:
It
is
recommended that all original packing materials be saved for reuse in case the
printer requires reshipment in the future.
1.4 Operation Site Selection
1. The FX-80/FX-lOO should be installed on a flat, firm surface with enough room
as shown below.
2. Care should be exercised in locating the printer in areas where it will not be
exposed to direct sunlight or where the environment contains grease or dust.
3. The FX-80/FX-lOO should not be located in the vicinity of noise generating
equipment or heat generating equipment.
4. Do not subject the printer to temperatures below SoC (41°F) or above 3SoC
(9S0F) during operation. Also avoid sudden changes in temperature and
extreme shock.
Interface cable
Computer
CRT display
0:
~FIOPPYdiSkunit
Laying Printer on Flat, Firm Surface
1-3

Advertisement

Table of Contents
loading

This manual is also suitable for:

Fx-100

Table of Contents