Tuner Section - JVC 0708DTSMDTJEIN Instructions & Installation Manual

General settings—PSM
Enter PSM menu. Select an item.
Indication Item ( : Initial) Setting
DEMO • DEMO ON : Display demonstration will be activated automatically if no operation is done
for about 20 seconds.
• DEMO OFF : Cancels.
CLK DISP * 1
• ON : Clock time is shown on the display at all times when the power is turned off.
• OFF : Cancels; pressing DISP will show the clock time for about 5 seconds when the
power is turned off.
CLOCK H (Hour) 1 – 12 : [Initial: 1 (1:00)]
CLOCK M (Minute) 00 – 59 : [Initial: 00 (1:00)]
DIMMER • ON : Dims the display and button illumination.
• OFF : Cancels.
SCROLL * 2
• ONCE : Scrolls the displayed information once.
• AUTO : Repeats scrolling (at 5-second intervals).
• OFF : Cancels.
• Pressing DISP for more than one second can scroll the display regardless of
the setting.
L/O MODE • REAR : Select if the REAR LINE OUT terminals are used for connecting the speakers
(through an external amplifier).
• WOOFER : Select if the REAR LINE OUT terminals are used for connecting a subwoofer.
WOOFER * 3
• LOW : Frequencies lower than 90 Hz are sent to the subwoofer.
• MID : Frequencies lower than 135 Hz are sent to the subwoofer.
• HIGH : Frequencies lower than 180 Hz are sent to the subwoofer.
AUX ADJ A.ADJ 00 : Adjust the auxiliary input level to avoid the sudden increase of the output
– A.ADJ 05 level when changing the source from external component connected to the
AUX input jack on the control panel.
TAG DISP • TAG ON : Shows the Tag while playing MP3/WMA tracks.
• TAG OFF : Cancels.
AMP GAIN * 4 • LOW PWR : VOL 00 – VOL 30 (Select if the maximum power of each speaker is less than
50 W to prevent damaging the speaker.)
• HIGH PWR : VOL 00 – VOL 50
AREA • AREA US : When using in North/Central/South America. AM/FM intervals are set to
10 kHz/200 kHz.
• AREA EU : When using in any other areas. AM/FM intervals are set to 9 kHz/50 kHz
(100 kHz during auto search).
• AREA SA : When using in South American countries where FM interval is 100 kHz.
AM interval is set to 10 kHz.
1
* If the power supply is not interrupted by turning off the ignition key of your car, it is recommended that you select "OFF" to
save the car's battery.
2
* Some characters or symbols will not be shown correctly (or will be blanked) on the display.
3
* Displayed only when "L/O MODE" is set to "WOOFER."
4
* The volume level automatically changes to "VOL 30" if you change to "LOW PWR" while the volume level is set higher than
"VOL 30."
MAINTENANCE
How to clean the connectors
Wipe the connectors with
a cotton swab or cloth
moistened with alcohol.
Connectors
Moisture condensation
Moisture may condense on the lens inside the unit. Eject
the disc and leave the unit turned on for a few hours until
the moisture has evaporated.
SPECIFICATIONS
Audio amplifier section
Power Output:
20 W RMS × 4 Channels at 4 Ω and
≤ 1% THD+N
Signal-to-Noise Ratio:
80 dBA (reference: 1 W into 4 Ω)
Load Impedance: 4 Ω (4 Ω to 8 Ω allowance)
Tone Control Range: Bass: ±12 dB at 60 Hz
Mid-range: ±12 dB at 1 kHz
Treble: ±12 dB at 7.5 kHz
Frequency Response: 40 Hz to 20 000 Hz
Line-Out Level/Impedance: 2.5 V/20 kΩ load (full scale)
Output Impedance: 1 kΩ
Subwoofer-Out Level/Impedance:
2.5 V/20 kΩ load (full scale)
If a kit is necessary for your car, consult your telephone
directory for the nearest car audio speciality shop.
Adjust. Finish
To keep discs clean
Wipe in a straight line from center of disc to
edge. Do not use liquid cleaners, thinners, or
benzene.
To play new discs
Remove any rough areas from the inner and
outer edges of the disc.

Tuner section

Frequency Range:
FM: 87.5 MHz to 107.9 MHz
(with channel interval set to 100 kHz or 200 kHz)
87.5 MHz to 108.0 MHz
(with channel interval set to 50 kHz)
AM: 530 kHz to 1 710 kHz
(with channel interval set to 10 kHz)
531 kHz to 1 602 kHz
(with channel interval set to 9 kHz)
[FM Tuner]
Usable Sensitivity: 11.3 dBf (1.0 μV/75 Ω)
50 dB Quieting Sensitivity: 16.3 dBf (1.8 μV/75 Ω)
Alternate Channel Selectivity (400 kHz): 65 dB
Frequency Response: 40 Hz to 15 000 Hz
Stereo Separation: 35 dB
[AM Tuner]
Sensitivity/Selectivity: 20 μV/35 dB
TROUBLESHOOTING
Symptoms
• Sound cannot be heard from the speakers. • Adjust the volume to the optimum level.
• The buttons on the unit do not work as you
intended.
• This unit does not work at all.
• SSM automatic presetting does not work.
• Static noise while listening to the radio.
• Disc ejects.
• CD-R/CD-RW cannot be played back.
• Tracks on the CD-R/CD-RW cannot be
skipped.
• Disc can be neither played back nor ejected. • Unlock the disc.
• Disc sound is sometimes interrupted.
• "NO DISC" appears on the display.
• "PLEASE" and "EJECT" appear alternately
on the display.
• Disc cannot be played back.
• Noise is generated.
• A longer readout time is required
("READING" keeps flashing on the display).
• Tracks are not played back in the order you
have intended.
• The elapsed playing time is not correct.
• The correct characters are not displayed
(e.g. album name).
• Microsoft and Windows Media are either registered trademarks or trademarks of Microsoft Corporation in the United
States and/or other countries.
Do not use the following discs:
Single CD—8 cm (3-3/16") disc
Unusual shape C-thru Disc (semi-transparent disc)
CD player section
Type: Compact disc player
Signal Detection System: Non-contact optical pickup
(semiconductor laser)
Number of channels: 2 channels (stereo)
Frequency Response: 5 Hz to 20 000 Hz
Dynamic Range: 93 dB
Signal-to-Noise Ratio: 98 dB
Wow and Flutter: Less than measurable limit
MP3 Decoding Format: MPEG1/2 Audio Layer 3
Max. Bit Rate: 320 kbps
WMA (Windows Media® Audio) Decoding Format :
Max. Bit Rate: 192 kbps
Having TROUBLE with operation?
Please reset your unit
Still having trouble??
Call 1-800-252-5722 (USA ONLY)
http://www.jvc.com
3 – EN
Remedies/Causes
• Check the cords and connections.
If you press M MODE, some buttons work differently from it
original function. Wait for 5 seconds or press M MODE again.
Reset the unit.
Store stations manually.
Connect the antenna firmly.
Insert the disc correctly.
• Insert a finalized CD-R/CD-RW.
• Finalize the CD-R/CD-RW with the component which you used
for recording.
• Eject the disc forcibly.
• Stop playback while driving on rough roads.
• Change the disc.
• Check the cords and connections.
Insert a playable disc into the loading slot.
• Use a disc with MP3/WMA tracks recorded in a format compliant
with ISO 9660 Level 1, Level 2, Romeo, or Joliet.
• Add the extension code <.mp3> or <.wma> to the file names.
Skip to another track or change the disc. (Do not add the extension
code <.mp3> or <.wma> to non-MP3 or WMA tracks.)
Do not use too many hierarchical levels and folders.
Playback order is determined when the files are recorded.
This sometimes occurs during playback. This is caused by how the
tracks are recorded on the disc.
This unit can only display alphabets (upper case), numbers, and a
limited number of symbols.
Warped disc Sticker and sticker residue
Transparent or semi-transparent
parts on its recording area
General
Power Requirement: Operating Voltage: DC 14.4 V
(11 V to 16 V allowance)
Grounding System: Negative ground
Allowable Operating Temperature:
0°C to +40°C (32°F to 104°F)
Dimensions (W × H × D):
Installation Size (approx.):
182 mm × 52 mm × 160 mm
(7-3/16" × 2-1/16" × 6-5/16")
Panel Size (approx.):
188 mm × 58 mm × 5 mm
(7-7/16" × 2-5/16" × 1/4")
Mass (approx.):
1.3 kg (2.9 lbs) (excluding accessories)
Design and specifications are subject to change without
notice.
Stick-on label