Miele CS 1011 G Operating And Installation Instructions page 18

Operation
Switching on
,
Do not leave the appliance
unattended whilst it is being used.
^ To ignite the burner, push the control
knob down and turn it anti-clockwise
to the large flame symbol. The ignitor
will make a clicking sound and ignite
the gas.
Operating a control will automatically
create a spark on every burner. This
is quite normal and does not indicate
a fault.
If the burner does not ignite, turn the
control to off "ß". Air the room or wait at
least 1 minute before trying again.
If the burner does not ignite the second
time, turn the control to "ß", and see
"Problem solving guide".
When switching on, re-ignition
sometimes occurs (1-2 clicks) if the
flame on the ignition safety device has
gone out briefly, or if the thermal
element is not hot enough, e.g.
following a gust of air.
18
Regulating the flame
Control the flame so that it does not
spread out beyond the sides of the
pan. As the outer part of the flame is
much hotter than the centre, the tips of
the flames should stay beneath the pan
base. Flame tips which extend beyond
the sides of the pan merely warm up
the air in the room and can also
damage pan handles and increase the
risk of injury.
^ To move from the high to the low
setting, turn the control
anti-clockwise until it meets a
resistance a. Then press it down
and continue to turn it past the
resistance before releasing it. You
can now select the setting you
require.
^ To move from the low to the high
setting, turn the control clockwise
until it meets a resistance b. Then
press it down and continue to turn it
past the resistance before releasing
it. You can now select the setting you
require.
Switching off
^ Turn the control clockwise to position
"ß".
This stops the flow of gas and the flame
goes out.