Installation; Before First Use; Electrical Safety - Black & Decker Dustbuster V1250 User Manual

Additional safety instructions for
batteries and chargers
Batteries
Never attempt to open for any reason.
u
Do not expose the battery to water.
u
Do not expose the battery to heat.
u
Do not store in locations where the
u
temperature may exceed 40 °C.
Charge only at ambient temperatures
u
between 10 °C and 40 °C.
Charge only using the charger
u
provided with the appliance/tool.
When disposing of batteries, follow
u
the instructions given in the section
"Protecting the environment".
Do not damage/deform the battery
u
pack either by puncture or impact, as
this may create a risk of injury and fire.
Do not charge damaged batteries.
u
Under extreme conditions, battery
u
leakage may occur. When you notice
liquid on the batteries, proceed as
follows:
Carefully wipe the liquid off using
u
a cloth. Avoid skin contact.
In case of skin or eye contact, follow
u
the instructions below.
Warning! The battery fluid may cause
personal injury or damage to property.
In case of skin contact, immediately rinse
with water. If redness, pain or irritation
occurs seek medical attention. In case of
eye contact, rinse immediately with clean
water and seek medical attention.
Chargers
Your charger has been designed for a
specific voltage. Always check that the
mains voltage corresponds to the voltage
on the rating plate.
Warning! Never attempt to replace the
charger unit with a regular mains plug.
Use your Black & Decker charger
u
only to charge the battery in the
appliance/tool with which it was
supplied. Other batteries could burst,
causing personal injury and damage.
Never attempt to charge non-
u
rechargeable batteries.
6
If the supply cord is damaged, it must
u
be replaced by the manufacturer or an
authorised Black & Decker Service
Centre in order to avoid a hazard.
Do not expose the charger to water.
u
Do not open the charger.
u
Do not probe the charger.
u
The appliance/tool/battery must be
u
placed in a well ventilated area when
charging.

Electrical safety

Your charger has been designed for a
specific mains voltage. Always check that
the mains voltage corresponds to the
# voltage on the rating plate.
Your charger is double
insulated.
Features
1. On/off switch
2. Release button
3. Dust bowl
Fig. A
4. Charging base
5. Charger

Installation

Fitting the charging base to the wall
The charging base can be fitted to the
wall to provide a convenient storage and
charging point for the appliance.

Before first use

Before first use, the battery must be
charged for at least 24 hours.
Use
Charging the battery (fig. D)
Make sure that the appliance is
u
switched off. The battery will not be
charged with the on/off switch in the
on position.
Place the appliance on the charging
u
base as shown.
Plug in the charger.
u
Switch on at the mains.
u