Single Operation Mode - Pioneer AVD-W6210 Service Manual

5

6.4 SINGLE OPERATION MODE

- To operate the Power Supply Assy only
1. Setting of the pin 41 (ST1) and 42 (ST2) of the IC1601 in single operation mode is as follows.
ST2 ST1
Normal operation mode
H H
Normal operation mode
H L
Single operation mode (Turns on with VTR2 source)
L H
Single operation mode (Turns on with VTR1 source)
L L
H : Not connect
L : Connect to the ground
2. Press the RESET button
*Operates by the Monitor Assy un-connecting.
*The composite video signal output (FRONT, REAR) outputs the composite video signal of each source.
- To operate the Monitor Assy only
Setting of the TP1, TP2 and TP3 in single operation mode is as follows.
TP2 TP3 TP1
L H H
L - L
L L H
H : Not connect
L : Connect to the ground
Contents of single operation mode
[For aging]
MVIPW : ON
MFLPW : ON
DIMMER : 5V (FFH)
± 0
BRIGHT :
± 0
CONTRAST :
WIDE MODE : Full size
[EEPROM setting mode]
MVIPW : ON
MFLPW : ON
DIMMER : The calculated value from coordinates of EEPROM data
± 0
BRIGHT :
± 0
CONTRAST :
WIDE MODE : Full size
[Touch panel test mode]
MVIPW : ON
MFLPW : ON
DIMMER : The calculated value from coordinates of EEPROM data
± 0
BRIGHT :
± 0
CONTRAST :
WIDE MODE : Full size
5
6
Contents
Contents
For aging (See p.66.)
EEPROM setting mode (See p.67.)
Touch panel test mode (See p.71.)
6
7
AVD-W6210/UC
7
8
A
B
C
D
E
F
73
8