Storage - Outsign 110 User Manual

1. SAFETY INSTRUCTIONS
Recommendations and safety instructions
[
THERMOCOUPLE, IGNITION ELECTRODE AND INJECTOR
Clean the thermocouple, the ignition electrode and the injector regularly (every 6 months if the appliance is used regularly).
Check the control valve turns properly. If this is not the case, replace the faulty component by contacting Customer Services (Section: "Maintenance,
Troubleshooting and Customer Services"). The valves are lubricated for life.
[ ]
SILICON FAT-DRIP BOWL
Remember to empty these bowls regularly in order to avoid overflows into the interior of the appliance. To clean the bowls, wash them in warm soapy water
then rinse in clean water. The bowls are also dishwasher-proof. Remove the silicone bowls when you are not using the appliance to avoid water collecting in
them. This also allows natural ventilation. Do not try to remove the bowls during use; risk of burns or even a serious fire.
[ ]
SILICON COOKING DOME
Ensure that, under no circumstances, the maximum temperature of 280 °C is exceeded.
The silicon cooking dome is easily washed using soapy water.
Can be hooked in place (see diagram opposite).
[
MOUNTING THE SIDE TABLE
Place the centring bush (1) at the opening in the casing provided.
Insert the wing nut (2) from the inside of the casing to the outside.
On the outside, position the silicon washer (3).
Place the screws (4) in the spaces provided in the side table.
Line them up and screw in from the inside.

Storage

Shut off the gas tap when the appliance is not in use.
You can store the appliance inside as long as the gas bottle has been disconnected and stored in a well-ventilated area.
Whenever the appliance is out of use for extended periods, protect it with a cover
2. INSTRUCTIONS FOR USE
]
]
(continued)
29
3. ANNEXES
3
2
4