Download Print this page

Starting And Stopping; Check Before Starting - Husqvarna 325P5X-series Operator's Manual

Husqvarna chainsaw operator’s manual
Hide thumbs

Advertisement

Check before starting

Inspect the working area. Remove any objects that could
be thrown out.
Check the cutting attachment. Never use blunt, cracked or
damaged equipment.
Check that the machine is in perfect working order. Check
that all nuts and screws are tight.
Make sure the chain is adequately lubricated. See
instructions under the heading Lubricating the cutting
attachment.
Check that the cutting attachment always stops when the
engine is idling.
Only use the machine for the purpose it was intended for.
Make sure that the handle and safety features are in good
working order. Never use a machine that lacks a part or
has been modified outside its specifications.

Starting and stopping

WARNING! The complete clutch cover and
!
shaft must be fitted before the machine is
started, otherwise the clutch can come loose
and cause personal injury.
Always move the machine away from the
refuelling area before starting. Place the
machine on a flat surface. Ensure the cutting
attachment cannot come into contact with
any object. Make sure no unauthorised
persons are in the working area, otherwise
there is a risk of serious personal injury. The
safety distance is 15 metres.
18 –
English
STARTING AND STOPPING
Cold engine
Primer bulb:
Press the primer bulb repeatedly until fuel begins to fill the
bulb. The bulb need not be completely filled.
Choke:
Set the choke control in the choke position.
Warm engine
Primer bulb:
Press the primer bulb repeatedly until fuel begins to fill the
bulb. The bulb need not be completely filled.
Choke:
Set the throttle to the start position by moving the choke
control to the choke position and then returning it to its original
position.

Advertisement

loading

  Also See for Husqvarna 325P5X-series

This manual is also suitable for:

323p4326p5x-series325p5x series325p5