Set Weather Alert Mode; Memory Mode; Save Channels Into Memory; Scan Channels In Memory - Uniden Bearcat 980 SSB Owner's Manual

4. Press MENU/OK to set Weather Scan mode to ON or turn the selec-
tion knob until OFF displays and then press MENU/OK to set it.
WXSCAN displays again.
If Weather Scan is
Left at these settings (WX mode, WX Scan), you will hear only weather
broadcasts and Weather Alert signals. To use your CB radio normally
while monitoring weather alerts, press WEATHER again.

Set Weather Alert Mode

Weather Alert mode only operates when you are in CB mode; it does not
operate in Weather mode. In CB mode, the radio sounds an alert tone
when it detects a 1050Hz tone on a weather channel.
Press and hold WEATHER to turn Weather Alert on. ALERT displays.

MEMORY MODE

You can store channels into memory and then scan only those channels.

Save Channels Into Memory

1. Tune to a channel in CB mode.
2. Press and hold MEM/SCAN until SAVE appears (about 2 seconds).
3. Release MEM/SCAN.
4. The radio stays on the saved channel.

Scan Channels in Memory

1. From All Channel Scan mode (see page 12), press MEM/SCAN
until MEM and SCAN display; the radio scans memory channels
only.
2. Press MEM/SCAN again to return to MEMORY mode or the last
channel scanned.

Listen to Channels in Memory

1. Press MEM/SCAN until MEM displays.
2. Turn the Channel Selector knob to hear the channels you saved.
ON
when you turn off the radio, it remains
E-13
ON
.