Analog Devices Blackfin Getting Started page 72

Evaluation Tools
The plug-and-play architecture of USB allows the emulators to be auto-
matically detected and configured by the host operating system. It can also
be connected to (and disconnected from) the host without opening the PC
or turning off the power to the PC. A 3-meter (9-foot) cable is included to
connect the emulators to the host PC, thus providing abundant
accessibility.
As a bonus, customers in an environment that does not allow them to
open their PCs without IS support will find that both emulators eliminate
the need to obtain that help and thus can be easily moved from the lab to
the local desktop to the laptop.
Features
• High speed USB 2.0 (backward compatible with full speed USB
1.0) interface and connector
• JTAG clock operation from 10 MHz to 50 MHz
• Support for all ADI JTAG processors
• Multiple processor I/O voltage support with automatic detection
• 1.8 V, 2.5 V, and 3.3 V compliant and tolerant
• 5 V tolerant and 3.3 V compliant for 5 V processors
• Multiprocessor support
• 14-pin JTAG connector
• 3-meter USB cable for difficult to reach targets
Analog Devices JTAG emulators are supported by VisualDSP++ only. The
HP-USB Emulator is only supported by VisualDSP++ 3.5 (and later
versions).
2-34 Getting Started With Blackfin Processors