Storage; Transport; Ordering Replacement Parts; Disposal And Recycling - Qualcast 30cc Original Operating Instructions

Petrol lawn trimmer
Hide thumbs Also See for 30cc:
Table of Contents

Advertisement

7.3 Storage

Please note: If you fail to follow these instructions
correctly, deposits may form on the interior of the
carburetor which may result in the engine being
more difficult to start or the machine suffering
permanent damage.
1. Carry out all of the maintenance work.
2. Drain the fuel out of the tank (You can use
a plastic petrol pump for this purpose,
which can be bought via our
HELPLINE 0151 649 1500).
3. When the fuel has been drained, start the
engine.
4. Allow the engine to run at idling speed until it
stops. This will clean the remainder of the fuel
out of the carburetor.
5. Leave the machine to cool
(approx. 5 minutes).
6. Remove the spark plug.
7. Place a teaspoon full of 2-stroke engine oil
into the combustion chamber. Pull the starter
cable several times carefully to wet the
internal components with the oil. Fit the spark
plug again.
8. Clean the exterior housing of the machine.
9. Store the machine in a cold, dry place where
it is out of the reach of ignition sources and
inflammable substances.
Fertilizers and other chemical garden products
often contain substances that accelerate the
rate of corrosion of metals. Do not store the
machine on or near fertilizers or other chemicals.
Restarting
1. Remove the spark plug.
2. Pull the starter cable several times to clean
the oil residue out of the combustion
chamber.
3. Clean the spark plug contacts or fit a new
spark plug.
4. Fill the tank. See the section entitled Fuel
and oil.
5. Complete steps 1-7 described under the
point entitled "Starting the engine from
cold".
18
Helpline No. UK 0151 649 1500 / IRE 189 094 6244

7.4 Transport

To transport the machine, first empty the
petrol tank as described in section 2 in the
section entitled "Storage". Clean coarse dirt
off the machine with a brush or hand
brush. Dismantle the long handle as
described 5.1.1

7.5 Ordering replacement parts

Please quote the following data when
ordering replacement parts:
• Type of model/Machine QG-PT 3041
• Article number of the machine (34.018.71)
• Identification number of the machine (11010)
• Replacement part number of the part
required
For our latest prices and information please
go to www.einhell-uk.co.uk

8. Disposal and recycling

The unit is supplied in packaging to prevent
its being damaged in transit. This packaging
is raw material and can therefore be reused
or can be returned to the raw material
system.
The unit and its accessories are made of
various types of material, such as metal
and plastic. Defective components must be
disposed of as special waste. Ask your dealer
or your local council.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Qg-pt 3043

Table of Contents