JVC Studio Kit KA-F5602U Instructions Manual page 12

Getting Started
Part Names and Functions (continued)
$
[PROMPTER OUTPUT] Prompter
Output Terminal (BNC)
Signal (prompter video signal) inputted
into the [AUX] input terminal of the remote
control unit will be outputted from this ter-
minal via the RM multi-pin connector.
Composite signal will be outputted. Video
monitor will be connected here.
%
[DC INPUT] DC Power Input Terminal
(XLR 4 Pin)
Apply DC power to this terminal if Remote
Control Unit RM-P210 is not going to be
connected. For DC power supply, use AA-
P250.
12
PROMPTER
OUTPUT
$
&
^
&
RM
^
[BREAKER] Breaker Switch
Breaker switch will trip and cut off the
power if the power consumed is higher
than the rated capacity. If the breaker
switch trips, confirm that there are no ab-
normalities and that the power consump-
tion does not exceed the rated wattage. If
no abnormalities are detected, press the
breaker switch before turning the power
ON again to put this unit in the operating
status. If this unit still does not function
properly, consult your JVC-authorized
dealer.
Screw Holes for Mounting Tripod
BREAKER
DC INPUT
%