Part Names; Power On/Off - BOXLIGHT Seattle X30N Owner's Manual

Part Names

Power ON / OFF
POWER indicator
AC inlet
Focus ring
Power off?
Please press
key again to power off.
Turning on the power
correctly connected to the projector.
2. The POWER indicator will light up in green.
Outlet
3. Press POWER button on the control panel or
the remote control to turn on the projector.
4. Rotate the zoom ring to adjust the screen size.
5. Rotate the focus ring to adjust the focus.
Zoom ring
WARNING
A strong light is emitted when the projector's
power is on. Do not look into the lens of the
projector or look inside of the projector through
any of the projector's openings.
Turning off the power
1. Press the POWER button on the control
panel or the remote control. The "power off"
2. Press the POWER button again while the
message appears.
3. When the projector enters "Standby" mode,
the POWER indicator will light up in green.
4. If you don't use the projector, remove power
cord.
WARNING
Do not touch around the lamp cover and the
exhaust vents during use or just after use, since it
is too hot.
CAUTION
Do not turn off the AC power for 60 seconds
after the lamp is turned on. Doing so could cause
premature lamp failure.
68
Back