Correct Usage - Toshiba MMK-AP0072H Service Manual

3-4. Correct Usage

When you use the air conditioner for the first time or when you change the SET DATA value, follow the proce-
dure below. From the next time, the operation displayed on the remote controller will start by pushing the
button only.
Preparation
Turn on the main power switch and/or the leakage breaker.
• When the power supply is turned on, a partition line is displayed on the display part of the remote controller.
* After the power supply is turned on, the remote controller does not accept an operation for approx. 1 minute,
but it is not a failure.
• While using the air conditioner, operate it only with
switch and the leak breaker.
3
1
Push button.
The operation lamp goes on, and the operation starts.
2
Select an operation mode with the "MODE" button.
One push of the button, and the display
changes in the order shown on the right.
• In HEAT mode, if the room temperature reaches to
the set temperature, the outdoor unit stops and the air
flow becomes LOW and the air volume decreases.
• In the defrost mode, the fan stops so that cool air is not discharged and PRE-DEF
3
Select air volume with "FAN
One push of the button, and the display
changes in the order shown on the right.
• When air volume is "AUTO
temp. and room temp.
• In DRY mode, "AUTO
• In heating operation, if the room temperature is not heated sufficiently with VOLUME "LOW
select "MED. " or "HIGH
4
Determine the set up temperature by pushing the "TEMP.
Stop
Push button.
The operation lamp goes off, and the operation stops.
REQUIREMENT
SET
CL
" button.
", air volume differs according to the temperature difference between set
" is displayed and the air volume is LOW.
" operation.
13
FILE NO. SVM-05052
button without turning off the main power
UNIT
Cooling only model
DRY
Heat-pump model
HEAT DRY
(Dehumidity)
AUTO HIGH
" or "TEMP.
1
2
4
COOL FAN
COOL FAN
is displayed.
MED. LOW
" operation,
" button.