Mix Send Levels; Mix Sends On; Stereo Mix Pan - Yamaha M7CL StageMix V3.0 User Manual

Yamaha Commercial Audio
b) Press the [MIX ON FADERS] button to access a popup screen which
allows direct selection of any Mix or Matrix Bus.
Choose the "Target Mix Bus" from Mix 1-16 and Matrix 1-8. The currently
selected Mix will appear as a white button with a check mark. Stereo pairs
appear as single large buttons.
When a Mix, Matrix or Master block is selected in the "Navigation/Meter
Bridge", the [SENDS ON FADERS] button is not available.

4.8.1 Mix Send Levels

When in "SENDS ON FADERS" mode, the fader in each channel strip
controls the level being sent from that channel to the currently selected
Mix Bus.
Note: if a Mix Bus is set to "Fixed" mode, send levels to that Mix Bus
are fixed at 0dB and cannot be adjusted. Mix Send faders will not
appear when a Mix Bus set to "Fixed" mode is selected.

4.8.2 Mix Sends ON

In "SENDS ON FADERS" mode, the [ON] button in each channel strip
is used to turn On/Off the Mix Send from each channel to the currently
selected target Mix bus.

4.8.3 Stereo Mix Pan

When a Stereo Mix Bus is active as the "Target Mix Bus", a Pan slider
will be available at the top of each channel strip in "SENDS ON
FADERS" mode. Adjusting this slider will change the Pan position for
that channel's send to the currently active Stereo Mix Bus. The Pan
position's numerical value appears above the slider.
If the Pan Link function is active for the currently active Stereo Mix Bus,
a link icon will appear below the Pan slider. When Pan Link is active,
adjusting a channel's Pan slider will affect the Pan parameter for that
channel to the Master Stereo Bus and all other linked Stereo Mix
Busses.
M7CL StageMix V3.0 User Guide
Page 14