188 Installing Options
Digital Recording Console 02R User's Guide
Wordclock Selection
1. Power on your DA-88 modular digital multitrack recorder and
then the 02R.
It is always important to observe the correct order for powering up
equipment in a studio. Start with the DA-88 and mastering recorders
and the signal processors, then the 02R, and finally the monitoring
amplifiers and other downstream gear.
2. Press the (DIGITAL I/O) button until the "Word Clock Select"
screen appears.
If the card was installed properly, the system software should correctly
identify it in the appropriate slot. The TDFI-1 digital I/O card
(CD8-TD) can be installed in any slot. You should install the first two
cards in SLOT1 and SLOT2 in order to access the direct out lines.
Note: If the W.CLK IN box is not showing a proper wordclock input (no
discrepancy between the input and selected wordclock frequencies), check
the BNC cable between the WORD SYNC OUT connector on the DA-88
and the WORD CLOCK IN connector on the 02R. Check that the DA-88 is
powered on.
3. Use the CURSOR buttons to select the wordclock source.
Use the CURSOR buttons to select the W.CLK IN box and press the
[ENTER] button.
4. When you select the wordclock source, the appropriate icon
should be inverted in reverse video.
See "Word Clock Select" on page 154 of the User's Guide for further
details.