Yamaha O2R Owner's Manual page 146

Yamaha digital recording console owner's manual
Hide thumbs Also See for O2R:
Table of Contents

Advertisement

42
MIXING Display Functions
Setting the Bus levels
1. Use the CURSOR buttons
to select one of the bus
fader icons.
2. Adjust the level of the
bus by rotating the
encoder wheel.
Digital Recording Console 02R User's Guide
The third screen shows the output and auxiliary buses and the stereo
output, plus level faders for the buses:
Select this screen by pressing the [SEL] button for the stereo output. You
can also select this screen by pressing the [METER] button until it appears
in sequence.
Peak Hold
The Peak Hold function can be turned on and off from any screen of the
METER display function. Clear the peak hold levels by turning the Peak
Hold off (select the PEAK HOLD icon and press the [ENTER] button) or by
selecting another display function. The dedicated control room output
meter peak hold is not affected when other display functions are selected.
When the 02R reaches CLIP digital signal distortion occurs. You must
Note:
ensure this does not happen. Digital distortion is very unpleasant sounding. There
are a several things you can do. If CLIP is reached, but the corresponding PEAK
indicator is not illuminated, you need to attenuate the channel slightly with the
Ø/ATT display function (see "Phase and Attenuation" on page 32 of the User's
Guide). Otherwise, back off the GAIN control a little (see "GAIN Controls" on
page 27 of the User's Guide).
Meter Source Points
The following table lists the meter signal source points:
Signal
Post GAIN and
MIC/LINE 1~24
A/D, Pre EQ
TAPE 1~16, EFF1, EFF2
BUS 1~8, AUX 1~8, STE
REO OUT
Source Points
Post EQ
Post EQ
Pre EQ
Pre Fader
Post Fader
Post Fader
Post Fader

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents