Honda HS624 Dealer Instructions page 9

4. Wheel-driven models only:
a. Apply waterproof grease to the axles.
b. Slide the wheels onto the axles.
c. Secure each wheel with the 8 mm clevis pin
and cotter pin.
d. Spread the cotter pin ends as shown.
5. All models except HS1132:
a. Apply waterproof grease to the chute gear teeth,
sliding surfaces of the chute, and chute bushing.
b. Install the chute bushing and chute assembly on
the snowblower.
c. Secure the chute assembly with the three
8 x 12 mm flange bolts, three chute retainers, and
three 8 mm thin flat washers, as shown.
d. Tighten the three 8 x 12 mm flange bolts to the
specified torque.
TORQUE: 22 N•m (16 ft-lb).
6. All models except HS1132:
a. Move the chute guide lever to the HIGH position,
and attach the cable end to the chute guide.
b. Install the cable on the bracket, as shown, and
tighten the locknut securely.
c. Slide the rubber cable cover over the end of the
cable adjuster.
HS624 • HS724 • HS828 • HS928 • HS1132 SNOWBLOWERS
WHEEL (2)
CHUTE ASSEMBLY
8 x 12 mm
FLANGE
BOLT (3)
CHUTE
RETAINER (3)
8 mm THIN FLAT
WASHER (3)
CHUTE BUSHING
CHUTE GUIDE
CHUTE GUIDE
CABLE
RUBBER
CABLE
COVER
LOCKNUT
CLEVIS
PIN (2)
COTTER PIN (2)
COTTER PIN
CLEVIS PIN
H
9 of 17