Place Product Upright And Flush Into Wall (Embedding In The Wall) - Pioneer PDP-61MXE1 Technical Manual

Special Installation (Place product upright and flush into wall (embedding in the wall))

2.4.6 Place product upright and flush into wall (embedding in the wall)

Carefully read the following before trying to embed the unit in a wall, and make sure to observe all the limitations specified
below.
Be sure to mount the unit so that twisting, bending, or other deformation of the unit does not exceed 4 mm.
(1) Embedding in walls with space provided behind the unit (with no obstructions within a distance of 300mm from
the back surface of the unit).
<Viewed from the Right Side>
Methods of Securing: Basic methods of securing are shown right. Avoid blocking or covering
areas aside from those indicated by
to fittings, double-check that the thickness and height of the fittings,
and the number of fixing bolts is correct. (Also refer to 2.4.1
"Mounting to fittings (pg. 21)".)
28
A
A
✩ Operating Temperature Restrictions
A: 0 to 300 mm
A
X (Front of the unit)
Y (Rear of the unit)
<Viewed from Above>
Temperature in space X and Y
. Before attaching the unit
A
0 to 40 °C