Charging Batteries; Simultaneously Recharging And Power Supply - TBB Trident Manual

Flooded
Freedom
GEL
AGM
Please read your manual of battery or consult the battery manufacture to
set the output voltage accordingly.

4.2 Charging Batteries

Before you start to charge batteries, please read the General safety information and
take all safety precautions when working with batteries.
ÿ
Read the section 4.1 to set the dip switch at proper situation.
ÿ
Check the manual or manufacturer of your battery and set the dip switch 4-6 at the
proper situation according to the recommended absorption and floating voltage.
ÿ
Plug in the temperature sensor to the battery charger and fasten the sensor head
directly to the battery.
ÿ
To assure the right charging and avoid the chance of over-temp in battery, it is
strongly recommended the temperature sensor should be connected during
charging.
ÿ
When the charging is completed, the battery charger enters into Floating Mode, and
the charged light is ON.
ÿ
Recharging: TRIDENT battery charger will begin a charging cycle 14 days after the
last cycle
.
WARNING
The battery charger is designed to have no output if no battery is
connected.

4.3 Simultaneously recharging and power supply

It is strongly recommended to check your DC load requirement if you are connecting DC
load while charging.
WARNING
If your DC load is voltage sensitive and did not permit high input over
14.5VDC, do not connect DC load while charging if you are charging
OFF OFF OFF
OFF OFF ON
OFF ON OFF
OFF ON ON
14.4V 13.3V
14.8V 13.8V
14.4V 13.8V
14.2V 13.6V