TBB Trident Manual page 14

Figure 3.1 installation guide for connecting BC and batteries
Mounting: Mount the battery charger on a vertical surface, using the mounting holes
provided. Mounting hardware should be corrosion resistant. Recommend to
use all four mounting holes.
Connecting DC wiring for batteries:
WARNING
All the batteries you are charging must be the same type, that is, all
should be flooded, or all gel, or all AGM.
ÿ
Plan the route the DC wires will follow trying to make it as short as possible.
ÿ
Install the DC circuit breaker or fuses in the battery positive circuits close to the
battery.
ÿ
Fully insert each positive wire into the positive terminal on the charger. Tighten the
connector and test that the wire is secure.
ÿ
Connect the positive cable from the positive wire terminals on the charger to the
battery fuse or breaker, which should be installed on the battery positive terminals.
Leave the DC disconnects or breakers in the OFF position until installation is
complete. Leaving them off helps prevent sparking when you actually make the
connection.
Connect AC wiring:
Make sure the AC source circuit is disconnected by turning off the breaker feeding