Insert Editing; Playback Zoom; Tape Counter - JVC GR-SX897 Instructions Manual

Compact vhs camcorder
Table of Contents

Advertisement

Playback Zoom

To magnify the recorded image up to 10X at any
time during playback. Make sure that the TBC
mode is activated.
R
1) Press PLAY
to find the scene of interest.
2) Press ZOOM (T/W)
end zoom press and hold W until magnification
returns to normal. Or, press STOP
R
press PLAY
.
• Due to digital image processing, the quality of the
image may suffer.
Animation And Time-Lapse
The remote control lets you set/release interval
time and recording time without setting REC TIME/
INT. TIME (
pg. 21) in SYSTEM MENU.
Animation
I
Each time ANIM.
changes in the following order: 1/4S, 1/2S, 1S, 5S
and no indication (off).
Time-Lapse
Each time REC TIME
time changes in the following order: 1/4S, 1/2S,
1S, 5S and no indication (off). Each time INT. TIME
d
is pressed, the interval time changes in the
following order: 15S, 30S, 1MIN, 5MIN and no
indication (off).
E
. Pressing T zooms in. To
Y
and then
is pressed, the recording time
I
is pressed, the recording

Insert Editing

You can record a new scene onto a previously
recorded tape. Only the video signal is recorded in
this mode.
1) Set the Power Switch
down the Lock Button
2) Play back the tape, locate the edit-out point and
a
press PAUSE
w
for more than 1 second to reset the tape
counter, then press it again for less than
1 second so that "M" appears.
T
3) Press REW
of the scene you want to replace, press PLAY
to view the recorded tape, and press PAUSE
exactly at the edit-in point where the new scene
should start.
4) While holding down INSERT
release PAUSE
5) To begin Insert Editing, press START/STOP
When the counter reaches "0:00:00", editing
stops automatically and the camcorder enters
the Insert-Pause mode. To end Insert Editing,
Y
press STOP
• During Insert Editing, the original audio will be
heard from the speaker.
• After step 4), "Retake" (
performed.
• The tape may stop slightly before or after the
designated end point, and noise bars may appear.
Neither indicates a defect in the unit.
26
@
to "
" while pressing
!
located on the switch.
. Press and hold COUNTER R/M
to go a little beyond the beginning
U
, press and
a
. w appears.
.
pg. 13) can be
R
a
O
.

Advertisement

Table of Contents
loading

Table of Contents