Operating The Simplygo Device And Changing Device Settings - Philips SimplyGo User Manual

SimplyGo User Manual
2� Continue pressing the Mode button to scroll through the Pulse, Continu-
ous Flow, or Sleep modes.
3� When your desired mode appears in the display, stop pressing the button
and wait� The display will return to the run time screen of the mode you
selected, and the device will operate in this mode�
Operating the SimplyGo Device and Changing
Device Settings
You can change all device settings using the buttons on the control panel�
This includes starting the device, stopping it,
silencing an alarm, and changing oxygen flow�
To start your SimplyGo device, follow these steps�
1� Connect a nasal cannula to the patient
cannula connector on top of the device,
as shown� Ensure that the cannula is
routed to prevent it from being pinched
or kinked to avoid a disruption of oxygen flow�
Note: A standard single lumen nasal cannula and tubing (not supplied)
should be used to deliver oxygen from the SimplyGo device� The device
works with cannula tubing up to 30 ft� (9 m)�
2� To start the device, press the Power button� After the first press, the
display screen and the 5 button backlights turn on and you will see
a screen similar to the one shown below, left� If the battery capacity
is 1/2 full and the battery is being charged, the screen will appear as
shown at right�
Note: The symbols and alarms shown on these screens are discussed in detail
in the Alarm Indicators and Display Symbols section�
16