Basic Connections; Tape Dubbing - JVC GR-FX36ED Instructions Manual

Basic Connections

1
Make sure all units are turned off.
2
Connect the camcorder to a TV or VCR as
shown in the illustration (
If using a VCR . . . go to step 3.
If not . . . go to step 4.
3
Connect the VCR output to the TV input,
referring to your VCR's instruction manual.
4
Turn on the camcorder, the VCR and the TV.
5
Set the VCR to its AUX input mode, and set the
TV to its VIDEO mode.
NOTES:
It is recommended to use the AC Adapter as the
power supply instead of the battery pack
( pg. 7).
If your VCR has an S-Video input connector,
connect the camcorder and the VCR using the
provided S-Video cable. This can improve the
dubbed picture quality (GR-SXM86ED/SXM85ED/
SXM76ED/SX56ED only).
To monitor the picture and sound from the
camcorder without inserting a tape, set the
camcorder's Power Switch to "
set your TV to the appropriate input mode.
Make sure you adjust the TV sound volume to its
minimum level to avoid a sudden burst of sound
when the camcorder is turned on.
If you have a TV or speakers that are not specially
shielded, do not place the speakers adjacent to the
TV as interference will occur in the camcorder
playback picture.
pg. 32).
" or " ", then

Tape Dubbing

1
Following the illustration on pg. 32, connect the
camcorder and the VCR.
2
Set the camcorder's Power Switch to "
turn on the VCR's power, and insert the
appropriate cassettes in the camcorder and the
VCR.
3
Engage the VCR's AUX and Record-Pause
modes.
4
Engage the camcorder's Play mode to find a
spot just before the edit-in point. Once it is
reached, press 4/6 on the camcorder.
5
Press 4/6 on the camcorder and engage the
VCR's Record mode.
6
Engage the VCR's Record-Pause mode and press
4/6 on the camcorder.
7
Repeat steps 4 through 6 for additional editing,
then stop the VCR and camcorder when
finished.
33
EN
",