Positioning the printer
Please read the following before you use the printer.
Use the printer within the recommended power range.
USA and Canada:
Europe and Australia:
The power cord, including extensions, should not be longer than 5 meters (16.5 feet).
Do not share the same power circuit with other high-power appliances, such as an air conditioner, copier,
shredder and so on. If you cannot avoid using the printer with these appliances, we recommend that you use
a voltage transformer or a high-frequency noise filter.
Use a voltage regulator if the power source is not stable.
You should setup the printer near a power outlet that you can easily reach, so that it can be easily
unplugged from the power outlet if there is an emergency.
Only use the printer within the following ranges of temperature and humidity:
Temperature: 10 °C to 32.5 °C (50 °F to 90.5 °F)
Humidity: 20% to 80% (without condensation)
You should use the printer in a well-ventilated room.
Put the printer on a flat, horizontal surface.
Keep the printer clean. Do not put the printer in a dusty place.
Do not put the printer where the ventilation hole of the printer is blocked. Keep a gap of approximately 100
mm (4 in.) between the ventilation hole and the wall.
Do not put the printer in direct sunlight. If you have to put it near a window, use a blind or a heavy curtain
to protect the printer from direct sunlight.
Do not put the printer near devices that contain magnets or generate magnetic fields.
Do not subject the printer to strong physical shocks or vibrations.
Do not expose the printer to open flames, salty or corrosive gasses.
Do not put objects on top of the printer.
Do not put the printer near an air conditioner.
Keep the printer horizontal when you carry it.
AC 110 to 120 V, 50/60 Hz
AC 220 to 240 V, 50/60 Hz
About this printer
1 - 3