Power Outlet; Turning Power On Or Off; Returning The Digital Piano To Its Factory Default Settings; Auto Power Off - Casio Celviano AP-460 User Manual

Power Outlet

After you finish assembling the stand, turn on the
Digital Piano. For details, see "Getting Ready" on page
EN-50.

Turning Power On or Off

1.
Press the P (Power) button to turn on Digital
Piano power.
• This causes the P (Power) button to light.
• When you turn on the Digital Piano, it performs a
power up operation in order to initialize its system.
During system initialization the tone button lamps
cycle on and off in the sequence for about five
seconds to let you know that system initialization is
in progress.
2.
To turn off the Digital Piano, hold down the
P (Power) button until its light goes out.
NOTE
• Pressing the P (Power) button to turn off power
actually puts the Digital Piano into a standby state.
Minute amounts of current continue to flow within
the Digital Piano in the standby state. If you do not
plan to use the Digital Piano for a long time or if
there is a lightning storm in your area, be sure to
unplug the AC adaptor from the power outlet.

Auto Power Off

This Digital Piano is designed to turn off automatically
to avoid wasting power after no operation is
performed for a preset amount of time. The Auto
Power Off trigger time is about four hours.
• You also can use the procedure below to temporarily
suspend Auto Power Off.
■ To disable Auto Power Off
1.
While the Digital Piano is turned on, press the
P (Power) button to turn it off.
EN-6
2.
While holding down the FUNCTION button,
press the P (Power) button to turn on the
Digital Piano.
2
• Auto Power Off will be disabled at this time.
NOTE
• Turning off the Digital Piano after performing the
above steps will re-enable Auto Power Off.
Returning the Digital Piano to
Its Factory Default Settings
Perform the following procedure when you want to
return the Digital Piano's stored data and settings to
their initial factory defaults.
1.
Turn off the Digital Piano.
2.
While holding down both the ELEC. PIANO 1
and FUNCTION buttons, press the P
(Power) button.
3.
Keep the ELEC. PIANO 1 button and
FUNCTION button depressed as the Digital
Piano performs the operation described
below.
(1) The GRAND PIANO (CONCERT), GRAND
PIANO (MODERN), and ELEC. PIANO 1 button
indicator lamps start to flash in sequence.
(2) The flashing sequence gradually increases in speed.
(3) After some time, the flashing will stop.
4.
Release the ELEC. PIANO 1 button and
FUNCTION button.
• The Digital Piano will initialize its internal system.
You will be able to use the Digital Piano in a short
while.
NOTE
• See "Turning Power On or Off" (page EN-6) for
information about turning power on and off.
1