Configuring Option 82 - HP ProCurve 2910al Switch Manual

IP Routing Features
Configuring DHCP Relay
Syntax: dhcp-relay option 82 < append [validate] | replace [validate] | drop [validate] | keep >
[ip | mac | mgmt-vlan]
append: Configures the switch to append an Option 82 field to the client DHCP
replace: Configures the switch to replace existing Option 82 field(s) in an
3-58
ID option and a DHCP client request packet is received on a multinetted VLAN,
the IP address used in the Option 82 field will identify the subnet on which the
packet was received instead of the IP address for the VLAN. This enables an
Option 82 DHCP server to support more narrowly defined DHCP policy
boundaries instead of defining the boundaries at the VLAN or whole routing
switch levels. If the MAC address option (the default) is configured instead,
then the routing switch MAC address will be used regardless of which subnet
was the source of the client request. (The MAC address is the same for all
VLANs configured on the routing switch.)
Note that all request packets from DHCP clients in the different subnets in the
VLAN must be able to reach any DHCP server identified by the IP Helper
Address(es) configured on that VLAN.

Configuring Option 82

To configure DHCP Option 82 on a routing switch, enter the dhcp-relay option
82 command.
packet. If the client packet has existing Option 82 field(s) assigned by
another device, the new field is appended to the existing field(s).
The appended Option 82 field includes the switch Circuit ID (inbound
port number*) associated with the client DHCP packet, and the switch
Remote ID. The default switch remote ID is the MAC address of the switch
on which the packet was received from the client. To use the incoming
VLAN's IP address or the Management VLAN IP address (if configured)
for the remote ID instead of the switch MAC address, use the ip or mgmt­
vlan option (below).
inbound client DHCP packet with an Option 82 field for the switch.
The replacement Option 82 field includes the switch circuit ID (inbound
port number*) associated with the client DHCP packet, and the switch
remote ID. The default switch remote ID is the MAC address of the switch
on which the packet was received from the client. To use the incoming
VLAN's IP address or the Management VLAN IP address (if configured)
for the remote ID instead of the switch MAC address, use the ip or mgmt­
vlan option (below).